...in market place. So a corresponding item is needed. Is there any suggestion? Check this link: ...
Question about 42DPC85 42 in. EDTV-Ready Plasma Television
...turns off as it heats up. If PTC is OK, could be an open D. coil. check resistance of your deggausing coil...around 24 to 50 ohms but not more than 100. ...PTC could be of 3 pins or 2 pins. Good
...check, look on power board for a flat component which may be labelled "PTC", "TC", "F" or similar. When de-soldered, it should read low ohms. If open (fail) it will read 0.L or whatever the DMM ...
...ptc. If all items check out according to the wire schematic in the console suspect timer as having open contacts. The motor switches will have to be tested according to the test on the tech notes and ...
Question about (B000194UBA) Compact Refrigerator
check thermostat could it be the module? Hi, I had the same problem. Mine turned out to be the PTC starter. Checked the compressor coil resistance and it ws fine. Replaced the PTC starter with Item #:
Question about Affinity ATF7000E Front Load Washer
...again then you will need to look at the PTC circuit & door latch assembly and check for any dislodged connectors or damage to cables. If these are Ok then the PTC circuit may have to be
...PTC's do not fail, however, if a window is "binding" then that will cause the breaker to work extra hard and in the end will cause premature failure and/or the fuse to "blow" Therefore check circuit ...
...in the freezer wall has iced up and cant blow cold air and needs the defrost heater and thermostat checked(hint:rear wall of freezer will have snow/ice/frost on it)if this is the problem,otherwise ...
...is recommended repair. Please get back to me if you have any other questions. Kevin when you said to check measure the resistance of the PTC. is that the wax motor/PTC? if is 1222ohms, is that
Question about ATF6000ES Front Load Washer
...PTC is not used on the microwave function so may be an additional fault. Check also the alignment of the door switches as this can also cause a similar fault. My best guess is if you remove the mag, ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions