...with no color bands usually green in panasonic they all look identical. Check them with a ohms meter to see if any are open. The ICs usually take out one or two of these resistors when they go
...check the resistors with an ohm meter? all 12 of them seem to be working. your convergence amps are bad they are the two large chips that are mounted to there own board they should read STK392-110 if ...
...meter reading drop at a stedy rate or very quickly down to nothing. If in dout replace, you could ask the guy in the shop to check as some read differantly then others. The other thing the Ohms or Up ...
Question about LC-X1220P - UPS battery - 1 x lead acid - 20 Ah (LCX1220P) UPS System
...meter shows 26 volts(2 12 volt in series) but wont run lawn mower. jumped 12 volt car battery and this runs mower at slow speed. is battery dead Sounds as if battery has internal short. Also have ...
Question about LC-X1220P - UPS battery - 1 x lead acid - 20 Ah (LCX1220P) UPS System
...check the voltage at the ballast. If you are proficient with a meter, I may be able to get the correct voltage reading from the MFG for you. If you need further help, post a reply/comment, and I will ...
...you discharge a capacitors to check resistors resistors should have one side unsoldered and lifted out of circuit then testing its rating with a ohms meter testing in circuit will give false
...check all door switches because they control light, fan, and turntable. If you are handy with a meter, set to ohms, disconnect one wire on side of switch, use meter to test, readings should show ...
Question about Viera TH-50PZ80U Plasma TV
...meter the two t8ah fuses they were both open i replace, they again open up I than unhooked all plugs from the power supply board except the 110 volt replaced the fuses they did not open up I than ...
...when I plug in to powerstrip or directly to wall. Someone said possible short. Pulled back cover. Checked ribbon between power supply and main board. Meter reads 5 when main not plugged into power. ...
meter on RX1, check your terminals. When your microwave door is closed you should have a reading of zero. Once the door is open the reading should change to infinity. If these readings do not match up
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions