Questions & Answers for: Yamaha FZR 1000 check gauge

...check the ignition coils, wires, all seem to show the right resistances as in the manual. The spark p;ug cap resistances are also fine. I put in new plugs, and get a good spark. Carbs were just ...

Back firing at idle My project bike is nearly ready to hit the road but I have not been able resolve the back firing problem. It is bad at idle, I found that if I turn the idle up to 1500 or so it ...

can i fit a fuel gauge and is it hard to fit a new engine and take the old one out fitting a fuel gauge could be a major as it will involve cutting a hole in the tank(personally i wouldnt do it)as you

it gas & between shifting.. Does anyone know what it could be Could be a few things but the 1st check would be the chain tension.It may be to tight.Put 2 people on the bike and check it then.Check

my temp gauge isnt working at all, and i checked the wires to the gauge and there all good and checked where they were ran to and they were fine. so i figured it might be a fuse, but i dont know where

...Any solutions...? Hi,,,sounds like you have a blockage in the carbs,,,remove and clean carbs,,check spark plugs too. I have a 92 FZR 3GM, it won't rev past 4k, but if I toggle the kill switch

...gauge, working lights... When i rode it home the first ten minutes took my breath away... loved it.. the rest of what turned out to be a 50 min journey timefor 20 miles was very dissapointing. I have ...

...looking for a neutral light, then I can hit start. I installed a new fully charged battery, and I checked all the fuses, the fuses are good, pulled and reseated them all too. No headlights, checked ...

light on tacho doesn't work speedo light works, tacho and fuel gauge lights don't You can change the globe, otherwise the wire + or - is broken

...my FZR 1000 runs great but then sometimes it is powerless and backfiring ....what should I check or look into fixing? back firing , can mean a lean (popping on deceleration) or a rich