Questions & Answers for: Harley Davidson FLHX Street Glide check gauge

...gauge. With a test light check for power to the sending unit, then remove the sending unit and manually operate the float arm slowly with the correct wiring hooked up to the fuel gauge and sending ...

...tugging at any joints you find to see if they pull apart easily. Crimped **** splices are best and don't need to be taped. Check the back of the gauge for loose connections as well. Hope this

...Cause the bike goes back to the shop again, for the third time in a month. Hi Anonymous, start by checking oil level in tank and make sure it is between the add and full mark. With engine at normal ...

...gauge. With a test light check for power to the sending unit, then remove the sending unit and manually operate the float arm slowly with the correct wiring hooked up to the fuel gauge and sending ...

...gauge Turn ignition switch to IGN. Check for voltage at terminal 1 of fuel gauge connector. If no voltage, repair the break. If voltage present, disconnect harness connector from speedometer. Check ...

Ground the yellow wire to see if the gauge goes to full, if not check all connections , if you can't find anything wrong with connections make sure you are getting voltage if all is good replace gauge

fuel gauge not working Hi Anonymous, check your instrument fuse and fuel gauge sending sending unit. Enjoy the video. Good luck

check the voltage to the O/W (+) wire and the BK (-) wire of the fuel gauge connector if the gauge did not indicate FULL and the correct reading will depend on the source voltage and the level of fuel

...Check electrode gap with a wire-type feeler gauge. Bend the outside of the electrode so that only a slight drag is felt on the gauge as it passes between the electrodes. The proper gap measurement is ...

...check out the oil pump. If the gauge shows oil pressure but the light does not go off it may be that the contacts in the pressure sending unit are not opening to break the circuit and shut off the ...