...gauge drive circuit check. . lf the vehicle speed exceeds 1.2 mph (2 km/h) or the ignition switch is turned OFF, the self-diagnosis mode ends. The Beeper Drive Circuit Check: When entering the ...
...gauge would only read from 3/4 full to 1/4 full. Car has 215,000 mi. Thanks. This sounds like a bad ground but first check the fuse for the instruments located in the fuse box. If that is OK, somone ...
...white gauge kit and needle will move but want move when i am moving car it is a 1991 honda accord Check cable from transmission to speedometer. The cable has a square end that goes into the
...gauge when you were messing with the gauge cluster, they can be very delicate. Check you connections real well. Could be also, just by coincindence that the sending unit in the gas tank has gone
Check Engine light and gauge needle lights don't work To pass emissions I have to prove that the check engine light works. They tell me that it should light up when the key turns all the accessories ...
honda accord not starting after gauges went harewire i checked the ground cable from the battery and its still in good contact are there any other groung cables i can check. (1991 honda accord) CHECK ...
...behind the passenger seat held down by 2 size 10 bolts. Before getting a new gauge kit, have you checked all the fuel system wirings and they are
...check to see if your fuel gauge is working by disconnecting the fuse from the panel, if gauge reads e then ground the fuel gauge if it reads full then the fuel gauge reads fine the its the float ...
How to check the oil pressure in a 1996 Honda Accord Remove your oil pressure switch and install a oil pressure gauge and start and check gauge.
...gauge operation. This function may be part of the on-board computer but the first thing you should check is the fuse continuity for supplying current to the instrument panel (and possibly other ...
Usually answered in minutes!
2,998 Questions
2,681 Questions
1,631 Questions
1,636 Questions
1,570 Questions