Questions & Answers for: Chevrolet Blazer check gauge

Question about 2000 Blazer

2 Answers

...check from the gauge to the actual sending unit that is located inside of the fuel tank. When inspecting the wires, you will need to look for worn or lose connections. make sure there is proper ...

Ad

Question about 1999 Blazer

1 Answer

...Check Gauges" light comes on when a reading from one of the sensors which controls the gauge cluster is out of spec, in other words, it should be accompanied by a low/high engine temperature, a low ...

Ad

...check gauge light on my 1992 Chevy Blazer came on. What does that mean? Hello nachelle_mar: My name is Roger and I will help you. The check gauge lamp is a warning that a failure of somekind happend. ...

Question about 1998 Blazer

1 Answer

check the gauge is working fine first so remove the terminal of the tempreture sender unit and ground it to the engine the gauge should go right over to hot. If not then you have either a wiring fault

oil pressure gauge goes to near zero and check gauges light comes on a 1997 chevy blazer Check pressure with an external pressure gauge. Proceed from the results of that test.

Question about 1997 Blazer

1 Answer

...on the vehicles instrument panel(cluster) that doesn't work? Check fuses. May need to check this from tank unit wire harness by gas tank for bad gauge or defective tank unit. Good luck, best

Question about 2001 Blazer

1 Answer

...gauge registers empty with a full tank of gas on my 2001 chevy S10 Blazer, we replaced the fuel pump, sending unit. The new pump and sending unit came with a new wiring plug. We made sure we wired it ...

check wiring and your dash gauge, you can pull apart the connector at the fuel tank, find the wire for the gauge sender unit  (its color coded-I dont kinow what the one for your car would be

Question about 2000 Blazer

1 Answer

...more than five min with the gauge not working its not the pump lol pull the oil pan and check voltage at pump, its likely either the wiring to the pump, the pump itself, or the the wiring for the ...

Question about 1997 Blazer

1 Answer

...gauge. Since it is showing 3/4 all the time. It is a break in the wire or really high resistance. I would check resistance of the ground wire first. If it is good(less than 5.0 ohms), I would replace ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...