Questions & Answers for: problem check drum

Ad

Question about Phaser 7700 Laser Printer

1 Answer

...check the +5VDC circuits up to Drum Motor J210-4. (WN7.3.6 +5VDC-2) Between Drum Motor J210-6 (+)GND (-) Is the voltage +24VDC? Yes No Using the wire network from Chapter 7, check the +24VDC circuits ...

Ad

Question about KM-1505 Copier

1 Answer

drum. ? Check the letter indicating the drum type printed on the new drum flange. ? Securely insert the drum shaft as far as it will go. When turning the drum shaft, turn it in the direction indicated

Ad

Question about FS-4000DN Laser Printer

1 Answer

...engine PWB. Check procedures/corrective measures: - Install the drum unit - Check the connection of connectors drum PWB (YC1) and connect-L PWB (YC3). - Replace the drum unit - Replace the engine ...

Question about FS-2000D Laser Printer

1 Answer

...engine PWB. Check procedures/corrective measures: - Install the drum unit - Check the connection of connectors drum PWB (YC1) and connect-L PWB (YC3). - Replace the drum unit - Replace the engine ...

Question about FS-2000D Laser Printer

1 Answer

...check the drum suport springs,,open the door and see if the drum has any lift in it,,if it has a lot of lift check the spring suports then check if the drum has a slight knock on it this would be a ...

Question about HL-5240 Laser Printer

1 Answer

...be able to find the way remove drum from the unit, then replace the new drum and fix it. Don not tough the edge wiper blade, rotate the drum and check whether it rotating smoothly in both

Question about IntelliFAX 2800 Laser Fax

1 Answer

...check drum message check drum displays, what do I do? The owners manual says the check drum message comes on when the drum hasn't been installed properly. It suggests removing and reinstalling the ...

Question about 2002 Blazer

1 Answer

...are in place and holding the shoes firmly on the backing plate . Check the drums are round and not oval shaped . Re adjust the shoe to drum clearance .Check that the hand brake cable is fully ...

Question about 2002 Blazer

1 Answer

Check the Drum Unit Relay PCB (Y) (UN26) 3. Check the Drum Unit Memory PCB (Y) (UN30) 4. Check the harness/connector between the DC Controller PCB (UN09/ J25) and the Drum Unit Relay PCB (Y) (UN26). 5

Check the Drum Unit Relay PCB (Bk) 3. Check the Drum Unit Memory PCB (Bk) 4. Check the harness/connector between the DC Controller PCB and the Drum Unit Relay PCB (Bk) 5. Replace the Drum Unit (Bk). 6

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Office Equipment & Supplies Experts

jasbo
jasbo

Level 3 Expert

2239 Answers

Ekse

Level 3 Expert

13434 Answers

Marvin
Marvin

Level 3 Expert

85161 Answers

Are you an Office Equipment & Supplies Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...