Questions & Answers for: Volkswagen Golf check cable

...check with the minimum of work.Assuming your speedo is run by a cable and not a transducer.Undo cable at gear box end and try to spin the plastic gear by hand should be free of binding or any other ...

Ad

Question about 1987 Golf

1 Answer

...but the gears are not engageing. CHECK CLUTCH CABLE! IF CABLES IS LOOSE YOU COULD HARDLY ENGAGE 1ST AND 2ND GEAR. IF YOUR CAR IS USING CLUTCH CABLE, ADJUST IT IF IT USES FLUID, CHECK THE RUBBER

Ad

Question about 1996 Golf

2 Answers

...to brake lights, so the problem might be in the cables going between the rear hatch and the frame, check the cables inside the rubber hose on the right side, one of the cables with current might be ...

Question about 1986 Golf

1 Answer

Check also that cable is fixed into pedal backside. If cable is OK, then the clutch disk it is stuck on its springs and stays opened. To fix this the clutch assembly must be taken apart, this is quite

...check the gas cable at the throttle body under the hood, it is possible the cable has either broken or become dis connected. remove the air cleaner and look into throttle body and find the rotating ...

...a case for a replacement clutch or the clutch cable? hi First adjust clutch cable, also check the cable how it is fitting is there any loose cable. if not getting change the clutch and pressure

. CHECK STARTER RELAY AND FUSE.REPLACE BATTERY CABLES IF YOU HAD THEM FOR A LONG WHILE.BECAUSE GROUND CABLE COULD BE BAD.TURN OFF RADIO FIRST BEFORE REMOVING BATTERY CABLES SO YOU WONT LOSE RADIO CODE

cable adjustment nuts until levers (arrow) on brake calipers lift off of stops. Maximum 1.5 mm (0.059 inch) from stop (arrow) is permissible on each side Pull parking brake on 3 times and then release

...CHECK ALTERNATOR FUSE.IF ALL IS GOOD YOUR ALTERNATOR FAULTY.BESURE TURN OFF RADIO FIRST AND INSTALL A PCM MEMORY IN CIGARETTE LIGHTER SOCKET.BEFORE REMOVING NEGATIVE BATTERY CABLE TO KEEP FROM LOSING ...

Question about 1990 Golf

1 Answer

gas petal not working stepped on gas petal and it fell to floor The linkage spring must be broken or the cable to the throttle body has broken. Check for broken cable at pedal end and throttle plate.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...