Questions & Answers for: Toyota Corolla check cable

Question about 2004 Corolla

2 Answers

...a problem with the cable. the cable could break any time. remove the cable and check if you rotate the cable inside in one end and if the other end is also rotating with it. tnx 4 using fixya, ...

Ad

Question about 1998 Corolla

2 Answers

...flow at the starter main cable that is coming from the battery cable? CHECK FOR VOLTAGE DROP CROSS ALL CABLES. Is there power at the main igniton wire at the starter when you turn the ignition

Ad

...cable (red). If ok, then check MAIN FUSE in the engine fuse box - replace of blown. If these are all good.....then, re-check the earth connections on the starter & alternator, including any other ...

cable adapter at the trans. Check your master cylinder, if low on fluid replace master cylinder. im having the same issue about to replace speedo cables both in 1992 toyota corolla i dont know if this

...cable and check that any retaining clamps or clips between the dash and the firewall are released. Safely raise the vehicle and support it on jackstands. Disconnect the cable fitting at the ...

Question about 1984 Corolla

1 Answer

...or positive cable loss connection , start at battery and hook jumper cables to the - neg batt post and to the body or frame. grab + positive cable and check all connections at battery down to

...Check cable between engine/gearbox and chasis, or bypass this cable during jump starting,by putting the - jump cable on the engine, if it starts your cable between engine and chasis has a bad ...

...Check that the outer cable should not be disengaged (moved) from the heater control assembly when the cable is pulled. Install the inner cable end of the defroster damper control cable to the heater ...

Question about 2005 Corolla

1 Answer

...cable terminal. If you may have had jumper cables connected backwards, you may have fried some electrical component. Get someone to read the codes which are making the check engine light come on, and ...

...selects the gears.....Something is slipping where you installed the bushing.....Check for proper cable adjustment....Apply the E- Brake while working with cable to prevent accidental

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1998 Toyota Corolla
1998 Toyota Corolla

1,231 Questions

2003 Toyota Corolla
2003 Toyota Corolla

1,240 Questions

2005 Toyota Corolla
2005 Toyota Corolla

1,236 Questions

1994 Toyota Corolla
1994 Toyota Corolla

819 Questions

1996 Toyota Corolla
1996 Toyota Corolla

767 Questions

Manuals & User Guides

Loading...