Questions & Answers for: Mazda check cable

...1989 the use a clutch cable no flu-ed needed Check the brake fluid resovoir, on the side there could be a hose coming off it part way down the side sharing the brake fluid to the clutch master ...

Ad

...Check the battery positive cable there is a problem with the positive side of the battery cracking open and corroding the cable. You may need to just replaced the battery and cable if the corrosion ...

Ad

...Check the starter solenoid. With my 93 Navajo I have experienced: Dirty connection(s) Starter solenoid Positive cable - hidden corrosion inside cable jacket Negative cableAnd always test the battery, ...

...Does it have a cable problem or sensory Not to sure, but i think its cable. Loosen the nut that holds the cable to the speedo drive on the gearbox. check if the inner cable is broken. Regards ...

...Check the battery cable connections at the opposite ends of the cables. The positive cable connects to the starter and the negative connects to the engine block. Make sure all connections are

or sandpaper. Hook them back up and retry to start. If it starts fine if not check the battery itself. Check the ground cable at both ends. If still no start check the starter and the starter soldnoid

Question about 2005 6

2 Answers

car tries to start like the battery is ab;out dead. had battery checked and was good. any theories? Chec to see if the starter connections are tight. If they are OK, check the cables and grounds for ...

...cable will be attached to the engine block for ground, check for loose bolt. If everything is tight, look for corrosion damage on the cables. You may need to get under the car to check the wires on ...

Question about 1988 MX-6

1 Answer

...cable, check both ends and just make sure that the outer cable is not loose and that the fittings on the end of the inner cable are not loose where they fit. when you adjust the cable (existing or ...

...cable s were hooked up backwards Jumper cables hooked up backwards no radio and lights inside car Connecting jumper cables the wrong wat around most likely has damaged electronic components such as a ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2004 Mazda 6
2004 Mazda 6

738 Questions

2000 Mazda MPV
2000 Mazda MPV

692 Questions

1999 Mazda 626
1999 Mazda 626

544 Questions

2001 Mazda Tribute
2001 Mazda Tribute

609 Questions

2002 Mazda Tribute
2002 Mazda Tribute

615 Questions

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...