Questions & Answers for: Mazda 323 how to check boost

gtx mazda 323 hi there my wee prob is my gtx has a external wastegate car was running stable 10psi now its either boost cutting or fuel cutting at 6psi and theres a beep under the dash when it cuts Im

I recently had my car jump started and now when I put the key in the ignition, the hazard lights flash and the horn sounds continuously. need to reset ur car alarm, once battery dies down and u boost ...

power failure over 100kms Car makes a loud beeping noise then the revs drop and power to the car cuts out. Car will turn back on after a few minutes and run like normal. Occurs over 100 kms mark. im ...

...there is gas in the carburetor and fuel filter. starter is good but i cannot re-start the engine. Check oil for coolant X oil cross mix Check cylinder compression Check cap for a line of carbon ...

mazda astina 1992 overheating when its underload. thermostat has been checked and the thermostat switch has been replaced I'd be looking at waterpump, belt that drives waterpump and/or fan clutch/ ...

...boost since mechanics worked on carburettor check to be sure they hooked up all the vacuum lines properly,, better yet take it back to them and have them do it,, that way your warranty stays in ...

...makes these faults to come up and undermine the working of the engine. So to start off we need to check from the fuel tank. Check if the fuel contains impurities and specially water. If so this can ...

1992 323 mazda want blow heat out REPLACE THERMOSTAT.IF ALREADY DONE.CHECK HEATER BLOWER MOTOR SEE IF POWER GOING TO HEATER BLOWER MOTOR.IF YES BLOWER MOTOR BAD.IF NO POWER GOING TO BLOWER MOTOR CHECK

I have a 2000 MPV Mazda 2.5 that crank but won't start. We checked every possible issues. We replaced fuel pump, ignition coil, crankshaft and camshaft sensors. We also checked the connectors for ...

boost leak". the waste gate is most likely internal on a factory system. On the turbo, You'll see a small, vacuum pod looking thing with a linkage connected. Check to make sure the vacuum line/hose is