...is the maintenance schedule like on the Yamaha WR 250 like? OFF-ROAD VEHICLES - Initial Service: Check carburetor adjustment, engine idling speed and starter operation/adjust if necessary, Change ...
take any revs just bogs down and near stalls, won't rev at all, any ideas any1. Unhook exhaust pipe,check port for blockage. if it is clear try to rev up with pipe off.If exhust is clear you will need
...and must be replaced, AGM batteries fail in this scenario more so than lead acid batteries. 14. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, ...
bike will not run...carb is clean, electrical is working, checked spark plug.... 1 does it have compression? 2 check your valves. 3 is it getting fuel?
how do u check the engine oil ;do they have a inspection glass On The Right Side under de brake pedal check for oil bubble
...battery, needs to be 12.5 volts or better and be able to pass a load test if necessary. 4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for ...
My lights work like candles Changed stator and regulator but nothing. Check ground wire, make a 12" jumper wire (remove plastic casing from both ends, touch wire to bulb socket and steel frame, if the
...across the battery terminals (you should have a reading of approximately 13.2-15 DC Volts). 3. Check Connections/Wires: Inspect the regulator/stator plug, and check the battery terminals for ...
...or damaged battery, you need 12.5 volts or better and be able to pass a load test if necessary. 11. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, ...
...and must be replaced, AGM batteries fail in this scenario more so than lead acid batteries. 14. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, ...
Usually answered in minutes!
98 Questions
61 Questions
7 Questions
3 Questions