...Control Unit (CCU) and the Motor Control Unit (MCU) cannot be sent correctly. Potential Causes ? Check Wire Harness connections to the MCU, the motor, and Central Control Unit (CCU) ? Check the ...
...ur needs,else choose fixya. ur problem might b due to, Refrigerator or freezer is not cold enough Check the temperature setting Assure that there is enough room for air flow in the refrigerator or ...
Question about 55612 / 55614 / 5561 / 655619 Side by Side Refrigerator
...sounds funny, then stop spinning and stops Can a repair man fix this? Please do the following checks * Level the dryer * Check the drum belt * Check the drum support rollers * Check the idler ...
Question about 55612 / 55614 / 5561 / 655619 Side by Side Refrigerator
...the freezer is working fine. What needs to be replaced? Dear customer, We recommend the follwoing checks when a refrerator isnt cooling properly Check the temperature setting Assure that there is ...
F11 Code Error Checked all connections, replaced CCU, still giving us F11 Code Ereror Hi. this is a Serial communication error This will occur when the Communication between the Central Control Unit ...
...between the Central Control Unit (CCU) and the Motor Control Unit (MCU) cannot be sent correctly. Check Wire Harness connectors to the MCU, the motor, and Central Control Unit (CCU) Check the Drive ...
I have a kemore Elite HE3 with a F11 code. It will restart and run for another min or so. I have checked the wires and connections F/11Serial Communication Error Communication between the Central ...
MY FREEZE WILL NOT GET COLD OR FREEZE ANYTHING Hello, Check the temperature setting Assure that there is enough room for air flow in the freezer or freezer Check for air flow restrictions in vents ...
...Clothes are drying as they normally do. Hello Biff You should the the following. Level the dryer Check the drum belt Check the drum support rollers Check the idler pulley Check the glides Check ...
Question about 14.1 cu. ft. / 399 liter Upright Freezer 23414
...and MODEL, but.. Kenmore HE2 front-load washer error codes F01. Main control board EEPROM error. Check/ ... F11. Motor control board failure. Check/ ... F20. Not filling. Check/ ... F21. Will not ...
Usually answered in minutes!
3,839 Questions
3,158 Questions
2,098 Questions
1,642 Questions
1,023 Questions