Questions & Answers for: Solid Audio channel run

...channel I purchased this amp and it came damaged. I belive that there was water damage to the pwer board. It is a seperate pleice but I belive I need a new one. I have been unable to find anything ...

amp i have 2 15inch soundstream dual voicecoil an my amp is autotek but when i run both sides my amp shuts down can u help gaidge of your wires or your speackers are blown. there may be a loose ...

my 12v touched my ground last night and big spark happened now the led light on my amp will not light up and i tried hooking up a different amp and its led light had come on and this morning my car ...

hi sir i have lot of confussion plz tell me sugesion . i want to run 2 woofer kenwood 3001 and 2 speaker 718 kenwood plz advise me iam baying solid audio amplifiere which series or reliable and low ...

Interference I made the mistake of leaving the Sub wires from the amp lying bare. After I reconnected the Sub I get a bad bass interference when the engine is running. Is there a grounding component ...

...run Well here is the stats 2000watts 2-channel Output Powers • 500W (RMS) x 2CH (2 Ohm) 500rms each channel • 600 (RMS) x 2CH (4 Ohm) 300rms each channel • 1000W (RMS) x 1CH (4 Ohm) If your talking ...

I just want to know if running this amp at 2Ohms is ok unless the amp says 2ohm stable dont somethings gonna fry try to get it to 8ohms you equipment will last alot longer

there is a engine noise coming out from my speakers i've already done sum solutions lyk attach a coil in amp, ground wire, etc. etc. (1) If you have an ohm meter check from neg terminal of battery to ...