Questions & Answers for: Honda channel run

...in my mother's 98 civic ex and didnt need any special tools. I do recommend replacing the glass run channels on either side of the window. I have replaced the regulator twice and it is still having ...

...turns but nothing happens going up or down. Any suggestions on how to fix? needs a window regulater and i reccomend a window run channel. (the rubber the glass slides in) if it doesnt operate

...run channel (rubber the glass slides in) and the regulator. or to get by if the regulator isnt bent take the door panel off, take the door glass out, the front of the run channel inside the door is ...

...run channel back into the window and slide it down/ that piece should thengo into glass and hold it into the run channel. if you have any questions let me know Please rate my response thank you very ...

...in its right place. TJ push the window to the rear so it sits in the run channel and opperate the regulator with the switch up/down untill you can install the 2 10mm bolts into the regulator and ...

...up with ''lake'' on passanger floorboard. sick of this ! Please send help ! You need to clean the channel drains, best way is with a long piece of semirigid wire that must have a blunt end so you ...

...run channel. The window regulator needs replaced and the rubber run channel needs inspected for damage and to make sure its properly seated into the window channels. note: make sure you install the ...

...run channel in a 1998 civic hx The problem is in the window rails they might of gotten loose or broken off. For this u need to remove the panels of the doors and check to see if they are unbolted or ...

...run channel, then remove the channel. Remove the regulator mounting bolts and remove the regulator. On later models, there are additional roller guide bolts to be removed. Mark the roller guide ...

...you did not clean them properly, you have to drain out the gas in the carbs and clean the air channels with thin wire, check the 2 ...