Amp I have installed a amp into a figerglass boat, the radio is new and is working. However after connecting the amp I have no sound. I feel that I have a bad ground, would this be the problem. And ...
Not rear channels I have the receiver connected in a standard factory replacement setup and there is nothing going to the rear channels. The fader is at 00 and I have swapped front/rear once and they ...
...the max out of them. thank you for you'r help you can run them on each channel..ive heard that putting them togethor sounds slightly better but ive never noticed a difference and i work at a audio ...
Question about XNBP12D Car Subwoofer
...run off of 2 channel instead of one?? or is it better to keep it running off one channel together and just bridge my amp to one channel You need to look at the specifications of the speakers and the ...
...channel to run this sub enclosure at 800 to 1000 watts rms to keep the speaker from blowing audiopipe apf1801 this amp will give you 1 channel @ 4 ohm x1 350 watts 1 channel @ 2 ohm x1 900 wats 1 ...
Question about 300W Class AB Bridgeable 2-Channel MOSFET Amplifier with Selectable Crossover
I have a 300 Watt dual amplifier connected to one 12" kicker dvc sub at 2 ohms. Every time the volume is turned up the protect light turns on. I had 2 of these kickers wired to a Rockford amp a ...
Question about 2-Channel Bridgeable MOSFET Amplifier (XPA4100) Car Audio Amplifier
...channel amp and i am not getting power to it. the way it is setup is from battery to 100 amp fuse, from fuse to inside cab of truck then to 500 K farad, Split from + to power on amp. Remote wire is ...
Question about XPA2100 2/1 Channel 300 Watt Amplifier Car Audio Amplifier
amp want power off Hello If your Dual Car Amp refuese to switch ON check the following. +12V wire is not connected or incorrect voltage. REM wire is not connected or incorrect voltage. Ground wire is ...
Question about XPA2100 2/1 Channel 300 Watt Amplifier Car Audio Amplifier
channel. Then, you could run the other two L & R channels for your mids and tweets (in stereo) on the remaining two channels; thereby in keeping a single amp to run the entire system. Also, 2 ohms
Usually answered in minutes!
185 Questions
53 Questions
49 Questions
30 Questions
25 Questions