...oil filter is. but it is not the oil filter its like it is leaking from above that and saturating the oil filter. does not look like the sending unit is leaking though, and after the car is running ...
Question about 2007 Impala LS Sedan New Cars
...the oil filter, but it doesnt look like the sending unit make sure the oil filter doesnt hav 2 gaskets sumtimes the old filter gasket will stick to the engine and if it double gasketed it will ...
...oil filter screws on to. What is this component called so I can obtain the proper gasket and try to repair? Thank you! That would be the oil filter adapter gasket. You might be able to find it t your ...
Question about 2007 Impala LS Sedan New Cars
...is unsuccessful. 07 Impala 3.5 Oil pressure sensor failure. sensor is located above the oil filter a long extension and a 27mm socket will get it changed out in 10 minutes. New sensor was 30 ...
...OIL FILTER 2006 IMPALA my 2007 Impala leaks oil and im thinking its the fliter housing its hard to get to but im going to take off the front bumprer to get to it seems tobe the best way to remove it ...
Question about 2007 Impala LS Sedan New Cars
oil filter adapter gasket on a 2007 impala Remove Front Right Side Wheel and Plastic well Covers Remove Drive Belt From A/C Compressor Undo The 3 bolts Holding the A/c Compressor To the Block Then You
filter adapter leaking oil Do you have 2 gaskets in there or is the leak on the adapter side? Have to remove the adapter & replace "o" ring or whatever.
Question about 2006 Impala
oil filter housing leak how to replace gaskit on a 2007 chevy impala Filter screwed on too tight,causing rubber gasket to bind and leak,loosen up. the oil filter needs a 1/2 turn tighter to stop leaks
...where the oil filter goes into the engine block, put it on a table where you can work on it. Dig it out. The company that made the adapter in the first place will have to help you find another
Question about 2007 Chevrolet Impala LS
...oil pan gasket replace how simple is it to change the gasket? does engine need to be lifted? can I get a diagram of drawing of oil pan features. torque specs, screw placement and order of tightening ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions