Questions & Answers for: changing inside door handle 1998

...part for a inside door handle.I trying to find some instructions on how to take the inside door panel off.and to install replacement handle. there are about 5 to 7 strews you have to take out the ...

...inside the door won't open when the handle is pulled but it will open from the outside standard problem; must replace the handle on the inside which entails drilling out rivets, etc. Easier to have a ...

...the van. remove door panel.. inside door you will see a rod going to the handle..on the end is a clip ..push the clip up off the rod .slide the rod out..remove 2 ..13mm nuts from handle ..remove ...

door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not

...handle out a little & put some needlenose pliers in the opening & grab the rod to open the door. otherwise unscrew the door panel & get into the inside of the door that way. good ...

inside door trim to gain access to the inside of the door, there may be plastic covering the large openings in the back of the door panel, you have to remove that as well to gain access to the rear of

door. The handle seems to be working properly; inside handle moves the cable that permits the door to close and open, but the outside handle is very loose and it appears to work. How do I fix the door

door. The handle seems to be working properly; inside handle moves the cable that permits the door to close and open, but the outside handle is very loose and it appears to work. How do I fix the door

door handle will not open door from inside will open from outside but not inside Did you take the handle off to see if it is connected to the rod to the latch ?

...inside door handle passenger side on a 2011 GMC Terrain? I've taken door panel off n it is held on by plastic rivets did not find any screws do I need to drill rivets out there was no hardware that ...