clutch bt could not get back into gear i changed the master and slave cylinder but still will not go into any gear Have someone push the clutch pedal while you watch the slave cylinder to see if it is
...clutch out?.if so its probably a universal joint either the one up by the tranny or the one by the rear axle. 4th gear in a gearbox is a direct drive (1 to 1 ratio) meaning both the input and out put ...
2. Clutch pedal Mounting Plate (possibly cracked)-this will cause improper gear engagement, hard gear engagement, soft pedal feel, insufficient clutch movement. *this plate is located above the clutch
...third you actually don't have to. Going from 3rd to 4th is even less of a distance. It may be a problem between the clutch and friction plates depending on when you last had them changed and
1992 toyota pickup wont shift gears changed clutch and transmission what else could it be? is the clutch pedal soft???
...clutch kit was installed , but not after then the clutch installation is incorrect probably find the the clutch plate has been installed incorrectly with a correctly fitted clutch kit , there is no ...
...If this valve is not trapping the fluid or if the rod connecting the clutch pedal to the master is not properly adjusted, the clutch wont fully disengage, causing the symtoms you've
94 toyta pickup chage starting hard shifting gear replace slay slender not solve -change clutch not slove problem change clutch hyd master cylender not sloved broblem some one say chage transmission- ...
...clutch kit-includes a new clutch disc, a new or reconditioned clutch pressure plate, and a new clutch release bearing. These three parts will restore your clutch. They all fit together between the ...
clutch wont engage tried to start the truck when it was -30 out and wouldn't start. when It warmed up it started but the clutch wont engage . not sure if I broke something putting the truck in and out
Usually answered in minutes!
914 Questions
745 Questions
525 Questions
407 Questions
393 Questions