Questions & Answers for: Isuzu changed clutch kit car wont

changed along with the clutch they may have installed the wrong fork therefore the clutch was never right from the start. Fixing to drop the transmission again but would like some advice on what to be

changed spark plugs and it stoped hyjakker , your engine was misfiring, this OP poster is not an engine question at all, .... so.... OP no person on earth can answer that. (can this fix it) P1870 with

thn its the gears. Guess you will have to replace the clutch pressure plate, its highly recomended though to replace the pro-kit,i.e the clutch plate, pressure plate and the release bearing. Good luck

...engine is on will not go into gear. Any idea where we should start looking to correct? Sounds like you put the clutch disk on backwards. Your not getting enough throw or you installed the wrong

clutch or transmission if you have to shut off the car to get it in gear then you either need to adjust the clutch or repair the slave cylinder.check your fluid level for the clutch,owners manual will

...clutch down and it stays there the car wont go into gear unless it is off it like i'm not pushing the clutch at all. I checked the fluid in the clutch hydraulic reservoir and its full. Is the pump ...

...clutch kit(clutch disc,pressure plate ,throw out bearing and pilot bearing)also have the flywheel resurfaced.The disc has gotten too thin to be clamped by the pressure plate.Best if you replace ...

and replace clutch as a kit, pressure plate, clutch plate, thrust bearing (comes as kit) but dont forget to check and or replace the spigot bearing in the rear of the crank shaft when doing clutch kit

How do refurbish the clutch slave cylinder? Clutch fluid are leaking out even when the vehicle is parked. Have difficulty getting vehicle into gear, clutch pedal stays halfway down. you dont, you ...

...Clutch Drag Kills Synchros take gears AUTOMATIC OR STICK TAKE GEARS MEANS ZERO. CAR WONT MOVE. (IN ALL GEARS? even in reverse) CANT START ENGINE IN GEAR? (STICK) cant shift by hand. cant shift gears ...