Kneading Blade Stuck on Kenwood Mixer KM300 The kneading blade on my machine is stuck inside and won't come loose for cleaning, changing,etc. Any ideas? Thank you. Lightly tap out the dough with a ...
mixer attachment I can't get my porcelian mixer attachment off. I used to be able to pull up and twist and it would easily come off? Seems stuck. make sure attachment is turned full counter clockwise ...
...washer that hold the "planetary" agitator section on the transmission shaft. 2. Remove the trim ring (if any) around the same. 3. The agitator section should now be able to be worked free. 4. Remove ...
...washer on top of main shaft. Using 9/16" wrench, remove double nuts and washers on both small shafts (the double bearing-retainer plate can stay screwed on). Using flat screwdriver, carefully pry ...
targa kitchen sink chrome mixer tap. circa 2002. plastic screw-in fitting at end of tap broken. replacement required. Contact the manufacturer and they will post a replacement which screws into the ...
Question about KSM90 Ultra Power Series Stand Mixer
kitchenaid mixer won't run changed out brushes and have changed them out in all 4 different positions The brushes need to be seated onto the armature. Try going from off to high quickly and tapping ...
tap the shaft. I did it by trial and error. You can adjust the depth by using a washer or two of varying thicknesses. I'm really surprised how lame a design using a press fit for this assembly is.
Question about KSM90 Ultra Power Series Stand Mixer
i recently purchased a set of basin and bath taps through amazon and noticed that the bottom of the bath mixer doesnt have a square piece for underneath the washer ...is there items missing ?? contact
Question about KSM90 Ultra Power Series Stand Mixer
7inch mixer lever tap is dripping how to fix Turn off the water to the taps. Screw the top off your taps and clean off the rubber seals from lime or dirt and then put back together nice and tight. ...
Question about KSM90 Ultra Power Series Stand Mixer
Hi I have replaced the cartridge in the mixer tap in the kitchen. However, the tap is still dripping. New cartridge was exactly same as old one, and seemed to fit perfectly. Any clues remove the ...
Usually answered in minutes!
493 Questions
357 Questions
324 Questions
285 Questions
205 Questions