Questions & Answers for: Mitsubishi Diamante how to change spark plugs

...spark plugs and wont turn over now and the engine is shaking bad and making wierd noises all from when i changed the spark plugs First, recharge your battery. While it's charging check to see if you ...

...Spark Plugs, Ignition Rotor, and Spark Plug Wires. Car was misfiring from Cylinder #2 due to a bad spark plug. (The guy who installed them dropped one or something) When I had the above changed with ...

I have a 2001 diamante 3.5 and need to change the rear sparkplugs I have a 2001 diamante 3.5 and need to change the spark plugs Champion Spark Plugs ONLY  RC10PYP4

spark plugs on 2002 diamante Hi, Get some tape - mark each spark plug wire with a piece of tape long enough to go around the plug wire and an extra 2 inches - -on that two inches left over - write the

...change the back spark plugs at the back as they are covered by the intake more than likely you will need to remove the upper plenum to change the rear plugs. You didn't list a year, model, or engine ...

change the spark plug, remove the engine cover and intake manifold plenum. Remove the spark plug cables. CAUTION: When pulling off the spark plug cable from the plug always hold the cable cap, not the

change all the spark plugs and leads myself.would i need to get a new casket for the cover?also,is there any other things i should watch out for ? as for the valve cover gaskets, if no oil leaks there

spark plugs and leads this can also lead to this fault. an damaged or week lead or spark plug will take more to get going. leads can wear out and go hard and crack inside. spark plugs gaine in the gap

how i change the spark plugs in a 2004 mitsubishi diamante Intake plenum removal will be needed to access the plugs.

change the spark plugs in the back of a Mitsubishi diamante 1994 - the car seems to have a miss. Please help! The wires are sparking fire In some cases, you may have to do it from under the car, using