Questions & Answers for: Cadillac how to change spark plugs

...change the spark plugs in my 1998 Cadillac STS 4 plugs in the front 4 in the back it is necessary toi remove some components to gain access to the rear bank of plugs There are 4 Spark plugs in the ...

...check the plug wire closely. if it has spark at the coil, then replace all the spark plug wires. i've changed plugs and wires also put new crank sensor, still throwing a PO 304? HELP whats

...spark plugs and the if i changed the oil an spark plugs and the car(cadiilac cts) it starts up but is missing what did i do wrong You might have crossed one of the plugs...another words, one of the ...

Spark Plug change. Translated you should be on you 3rd set of Spark Plugs and 2nd set of wires. When working in the engine compartment and with the electrical system remember: ther is 40,000 to 75,000

...SPARK PLUGS NOT HARD TO CHANGE.YOU NEED A LONGER SPARK PLUG SOCKET OR YOU USE REGULAR SIZE PLUG SOCKET USING LONGER EXTENSIONS.YOU NEED SPARK PLUG BOOT PULLER.YOU NEED A UNIVERSAL JOINT.BESURE TO GET ...

...spark plugs and wires. Now at a stop the vehicle conks out while in drive Had a code that indicated spark plug wire number 7 was bad. I changed out spark plugs and wires one by one so as not to get ...

...spark plugs. think if 4 years old some amount of miles on them they should be changed. a lot can be sorted from just changing the spark plugs. if plugs are sutty or brown they should be changed. also ...

...spark plugs and coil packs on 3,4,5. Still returned P0303 so I tested by switching out coil pack to 1 and spark plug to 5. It returned a P0305 so I changed the sparked plug again. It cleared the ...

change spark plugs REMOVAL PROCEDURE Remove the ignition control modules. Clean the spark plug recess area with low pressure air. CAUTION: Wear safety glasses when using compressed air, as flying dirt

...spark plugs and changed cylinder #1 on my 2006 cadillac srx but now its shaking what did I do wrong? It wasn't shaking before How do you change a cylinder? That's generally a major machine-shop ...