...rear window works, the rest do not. Does this mean the switch on the brake pedal is ok? The fuse is fine. None of the brake bulbs light and they all seem OK. How are these integrated with park ...
...2010 Chevrolet Malibu's. Recall #13036: "Brake Lamp Malfunction". The dealer will repair the body control module and brake pedal position sensor connector and harness. The following parts were ...
but whether or not this is warranted may be another issue. A third brake light can't ever be that hard to repair for a dealer.Try checking the electrical connector which goes into the brake light
...rear window stop light works has blown globes in other 2 tail and stop are different circuts fit 2 new globes only go in 1 way If replacing the two brake lights doesn't do it, check the ground ...
How to replace rear window brake light 2010 malibu Thru the trunk. Holes were cut out to access the bulbs.
...change brake light switch still no hazard lights or brake lights fuses are all good where is the relay Brake lights /rear hazard lights not working - Ford Truck ... www.ford-trucks.com > ... > 1967 - ...
...2010 Chevy Malibu lt Remove the rear window package shelf. Disengage the rear window shelf insulator from the rear shelf trim panel in order to get to the high mount stop lamp screws. Disconnect
...brake light on a 2010 malibu has a short? I think Check the wire connection to the brake light, follow the wire as far as you can, A pinched or split wire can minimize electric current flow enough to ...
...change both relays with the same brand. The turn signal, brake light, and flasher are on the same wire. I would take a circuit tester light and trace the wire to see where you lose the voltage. It ...
...brake lights? I changed the switch and nothing changed. Were is the fuse or relay located if there is one? No there isn't. The Body Control Module (BCM) takes care of that. Check the grounds that are ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions