...change the bulb from inside the engine compartment . raise the hood and feel for a plastic retaining ring in the back of the headlite. Loosen 1/4 turn and bulb socket and old bulb will pull out from ...
isn't difficult to remove the cover and you are likely due for a lube change anyhow. Good luck!! The only part of the number that may be the ratio is the 352 which could be 3,52:1 but don't trust that
Question about 1989 S-10 Blazer
...change the ring and pinion gear. The side and spider gears should not have to be changed unless there is something wrong with them.Changing a rear end gear set takes a fair bit of knowledge and ...
ROUGH IDLE MOWER STARTED IDLEING ROUGH AFTER RECENT FILL UP. THOUGHT MIGHT BE BAD GAS. CHANGED THE GAS , PLUGS, FUEL FILTER. STILL ROUGH IDLE BUT STARTS FINE.????? You-Tube video "LMDl_dAv2zI" ...
...number 2 plug. What is the cause of this? Either worn valve guides, valve guide oil seals on that particular cylinder, or worn piston rings. You need to perform a compression test to find out which ...
...car now and dont no what to do, i want to get it fixed and keep it but im thinking what are the changes of having flywheel changed and it still doesnt work, the engine management light isnt on??? ...
Question about 2004 Liberty
number 1 spraying fuel once ignition is in (on) position Sounds like the relay is stuck in an open position and needs to be replaced. Likely the O ring on the top of the fuel injector that seals it to
Question about 2004 Liberty
...number of possible reasons to get smoke including: Cylinder bore scored, causing rings to not seat. Damaged rings during piston replacement Valve guides leaking Mixture wrong (is smoke blue, white or ...
Question about 2000 Ram 1500 Truck
...change the ring and pinion .dose the teeth of the ring and pinion reer and front should be same number of teeth NO--- Check Gear Ratio On Tag Or Tube--Front and Rear Are Not The Same. Or Count Teeth ...
Question about 2000 Ram 1500 Truck
...change the spark plug? Do that first or swap plugs with number 3 and see if the miss moves if not it's time for you to perform a Compression Test and Leak Down test to see if it's a bad valve or ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions