Questions & Answers for: Chevrolet Venture how to change map light

...change oil light on message center after changing changed oil cannot erase light saying change engine oil I had a chevrolet truck with the same thing. You had to turn key on (do not start) and press ...

1999 chevy venture It was idiling and started to sputter real bad then dies, wont start again. Changed map sensor, got new plugs. Also replaced coil pack and moule. check fuel pump check the water ...

Change Oil light is on and oil has already been. How do you reset it turn key to on position do not start vehicle, depress gas pedal to floor three times the oil light comes on every 3,000 miles or so

...4.5 volts. If there is no change in MAP sensor reading on the scan tool, replace MAP sensor. MAP Sensor DTC's: P0105, P0106, P0107, P0108 and P0109. Hope helps (remember rated and comment

...light does not come on the van will crank and idle but when i push the gas petal it bogs down and will cut off.the repairs i have done are as followed new fuel pump,fuel filter,pressure regulator,map ...

...MAP sensor. Next is the fuel pump... change the filter first... as it could be clogged up and not allowing the fuel to pressurize enough.. to fire the injectors... let us know how it goes! Have you ...

2001 chevy venture stalls when first starting to drive cold and only when cold have scanned it and replaced the map sensor due to not holding vac have looked for bad ground as the turn signal lights ...

...light push lens One of the two,interiror, side by side courtesy or map lights mounted in ceiling (over dash) is supposed to operate by pushing lens. It feels as if the lens is loose and light is now ...

...map or iac forward and reverse, hot or cold, first shift(commonly reverse backing out of parking space) sometimes, but other times not related in any way to shifting or pedal position or pedal ...

...MAP change during the EGR flow test an engine that is running poorly due to mechanical condition such as worn piston rings, ect. can cause low engine vacuum thus EGR flow test will fail excessif ...