Questions & Answers for: Chevrolet Corsica how to change map light

...crank postion sensor, cleaned throttle body, vaccum lines checked and good. MAP and MAF sensors changed, changed fuel pump and sock, fuel pressure good, bleed schrader Exhaust extermely hot (red) ...

under throttle engine cuts out when and dies.then starts. 2.8 v-6 dies under throttle and restarts.fuel filter replaced and fuel pump. possible map sesnor

map sensor, alternator is good battery is good, I can get the car to start but it shuts down after a couple mins then restarting the car is a no go after a while, Is your fuel pump working & if it

...change it and/or the map sensor. I am thinking....an air leak at the hose (a crack in the plastic tube )to the MAP because you are also getting a 34 code ....knock sensor....and it may be affected by ...

1990 chevy corsica 3.1 liter v6 engine. started ran fine went shopping and on my way home it dies out of no where, start it back up give it gas dies again. it will run in idle but sounds rough and as ...

starts then shuts down check all your vaccume hoses for leaks, cracks or if they are not connected properly. Map sensor vaccume hose will cause this if it is broken or cracked.

light lens to change the light....Pop your trunk and look for 3 or 4 black large plastic wing nuts. Unscrew these and your lens will come off of the car....Twist socket out of lens and replace bulb...

where can i locate the map sensor 1988 corsica It is in the center of the firewall mounted to the relay block

I HAVE A 91 CORSICA STARTS THEN DIES TRIED NEW FUEL PUMP,MAP,SENSOR,COIL PACK ANY OTHER IDEAS if it dies when u put in gear i would try unpluging the harness on the transmission could be ur torque ...

...fine in park but sputters in drive and once the transmission goes into overdrive at about 60 mph. Changed the MAP sensor and it seems a little better when in drive and stationary but still sputters ...