belt the belt on my dc 14 will not turn does that mean i need a new belt and how do i get it changed Hi. Your Dyson will probably have A clutch unit this engages the brush roller when you pull the ...
change. To get at the switch, firstly pull off the bag/syphon box and then remove the handle. Behind the handle you will find 2 torx screws and 3 clips, when you have removed the screws and the clips,
Question about DC14 All floors Bagless Upright Cyclonic Vacuum
...I change the switch on my dysom dc03 cant find the way in any advise would be very helpfull thanks Pete unfasten the handle from the back then slide it back towards your self then the switch is ...
Question about DC14 Bagless Upright Cyclonic Vacuum
...animal works fine in Vaccuum mode but when I switch to the extendable tool the sound of the vaccuum changes to a higher pitch noise and I get very little suction through the hose. Any suggestion Your ...
Question about DC07 Bagless Upright Cyclonic Vacuum
...change the cable. i have taken a cover off near where the cable goes into the machine but now cannot get any further how to open the cover near the cable for dyson upright vacuum You will basically ...
Question about DC05 Cylinder Bagless Canister Cyclonic Vacuum
...hand check that the latches and plastic end bits aren't cracked. Alternatively the dc05 can be changed to using normal 32mm vacuum handle and rods, it wont have the clips but it will be much ...
...change the setting to the middle or "floor"/ low.On the other hand, here is a silly experience we may be sharing- sometime these units have wheels set so that, when the unit is "parked" or upright, ...
Question about DC14 All floors Bagless Upright Cyclonic Vacuum
dyson dc14 stopped working.....it does not switch on. I have checked the switch it seems fine.....changed the fuse even that did not resolve the problem....taken the filter out cleaned it and put it b
Question about DC33 Multi-Floor Upright Bagless Vacuum Cleaner
change from using the wand to an upright position the grey button will not clip into place properly so when I draw it back,the handle comes away although it looks as though it has gone back into place
Question about DC14 Animal Bagless Upright Cyclonic Vacuum
...handle into the floor vacuuming position the brush spins. If you were able to remove the brushroll an reinstall it the brush roll belt is likely very stretched out because otherwise it is very ...
Usually answered in minutes!
1,132 Questions
870 Questions
836 Questions
655 Questions
597 Questions