Question about Ultimate G Bagged Upright Vacuum
...something is not catching to hold up the long arm. I figured out that when mine did the same thing, it was time to change the bag. It was too heavy for the handle to handle! LOL Hope that helps. ...
need instructions dont have instructions manual for kirby g 2007 limited edition Here are instructions for changing the belt. I have manuals too! ...
...change from the long handle to the short if you'd like also. You get the handles off by pushing the "seatbelt button" located at the rear bottom of the handle and pulling the handle straight up and ...
Question about Ultimate G Bagged Upright Vacuum
...change the belt on my Ultimate G Diamond Edition When I turn the lever to belt off it engages the belt. When I turn the lever to belt on, it seems to be backwards and won't pick up the belt. Help! ...
kIRBY g5 wHEEL CHANGE hI CAN YOU PLEASE TELL ME WHAT SIZE CIRCLIP PLIERS i NEED TO CHANGE THE REAR WHEELS AND THE CIRCLIP SIZE PLEASE THANKYOU It is 0.027 inch thick and 0.28 inch inside diameter. Or ...
Question about Ultimate G Bagged Upright Vacuum
...change direction. Jiggle go forward,jiggle go in reverse. It seems as though it helps to push the handle at an angle to the left depressing the switch on the left side at the base of the vacuum head. ...
...change the outer bag clip? Can't figure out how to get the top apart to put in the new clip. The clip that goes to the handle. I had a Kirby Classic and I had to slide off the clip.Don't rate me if ...
handle falls back on kirby vacuum handle falls back You need to change handle holder (the one with spring at the bottom of handle), mostly spring disconnected and it can,t be fixed.
Question about G6 Bagged Upright Vacuum
...change back to upright cleaner I can never get the belt to work I turn the handle to line up the green dots but this does not seem to engage the belt so it does not turn Hi Andy, Please ...
Question about Ultimate G Bagged Upright Vacuum
...switch then transmission stopped working Looking at wire connections, linkage or belt I can see no changes or bad connections. Unit acts like in neutral when switched to drive common fault when ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions