Questions & Answers for: change clutch slave cylinder 1991

Ad

...then to rebuild them Maybe try bleeding the clutch and then the clutch slave cylinder this happen to myne and after i bled the clutch it was fine. maybe a bad clutch master cylinder as

Ad

Question about 1991 Wrangler

4 Answers

...clutch, one of the hydraulic cylinders hs failed, there is a master and a slave cylinder. The most likely and most common cylinder to fail is the slave cylinder, this requires the transmission to be ...

Ad

...clutch on a 1991 jeep wrangler 1. Fill master cylinder reservoir with DOT 3 brake fluid. Raise and support vehicle. Attach bleeder hose to bleeder screw on bleed line of slave cylinder. See Fig. 1 ...

...sounds like your hyadraulic clutch master have internal leak lose pressure, I suggest you to replace the hydraulic clutch kit to fix it. I think the slave cylinder is inside the bellhousing, big

...slave cylinder or both? yo it could just be out of fluid! it could actually the master cylinder because all the gear changing with the clutch goes through the master cylinder but i would go to the ...

clutch system. If it's low, likely you have a leak so check where the rod goes through the firewall under the dash, the line itself and the slave cylinder (some are outside the bellhousing, others are

clutch slave cylinder located at side of ur transmission,usually drvr side is leaking fluid.if this is the case u will notice clear brake fluid at the bottom center of ur trans,right where it butts up

My 91 jeep wrangler wont hold clutch fluid. I have had to fill it 2 times in the last 4 days. Any idea why? Leak in the clutch master or clutch slave cylinder. Have them checked out.

Question about 1991 Wrangler

1 Answer

...clutch or if its cable operated, you can only bleed hydraulic clutches, to bleed it you would bleed at the ******, you will see the bleeder screw on the slave cylinder that operates the clutch

...clutch slave cylinder on the bellhousing.  Open the bleed valve and have someone push the clutch pedal slowly to floor, and hold. Close the bleed valve, and repeat until fluid comes out in a ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85160 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

22108 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...