Question about WM-1485FHD Front Load Washer
...change the belt. If the motor isn't running, the lid switch may be defective. If so, the washing machine can't spin and may not function at all. The switch is inside the washing machine main housing ...
...change the belt. If the motor isn't running, the lid switch may be defective. If so, the washing machine can't spin and may not function at all. The switch is inside the washing machine main housing ...
...change the belt. If the motor isn't running, the lid switch may be defective. If so, the washing machine can't spin and may not function at all. The switch is inside the washing machine main housing ...
change it. A bad lid switch may cause the washer to not work at all. Now, if your pump is pumping and the washer still won't spin, you will want to check your belt and clutch. Once again, the belt
change it. A bad lid switch may cause the washer to not work at all. Now, if your pump is pumping and the washer still won't spin, you will want to check your belt and clutch. Once again, the belt
wm1815cs doesnt doesnt spin changed the sensor for le error but now the machine doesnt spin only water fills but doesnt rotate No spin, or lite spin try these: Using a multi meter check for continuity
...the pulsator. 3. Check the thread of the clutch if the thread is damaged means just make a thread of the clutch dont change the clutch bcz cost is high. You ready to pay means better change
Question about WM1815CS Front Load Washer
Model Wt-h550. What does fault code AE indicate? manual says it's clutch error but clutch operates fine. Replaced PCB on front under button controls but not rear corner PCB This error AE normally ...
Question about WM1815CS Front Load Washer
There is noise in LG top load fully automatic washing machine Gear Box. Can it be rectified or repaired? Hello... Noise is coming from clutch just change a new clutch assembly.
...is continue working and the clutch continue changing. Can you please help me what is the problem? I changed also the clutch motor but same problem. The carbon brushes are worn out and need to be ...
Usually answered in minutes!
1,845 Questions
401 Questions
404 Questions
243 Questions
245 Questions