Questions & Answers for: Ford how to change a clutch

...fading gently to silence.... engage and drive off normally, no sign of slipping. On move, low rev changes easily done, but more energetic accelleration causes sticky changes, mainly 2nd to 3rd. ...

...change compressor clutch on ford f25 Hi, I have a Ford F250 '03 6.0 diesel. The compressor clutch is slipping. How do I change this out? Do I also need to change out the pulley? Thanks, Kyle dont ...

...clutch has gone bad. You can either change the whole compressor, or just have the clutch changed on the compressor. You are better off having the whole compressor changed; by the time you pay the ...

...clutch and cannot change gears. Bleeded the clutch hydroulic system and got the clutch operating normally but still can't change gears. When engine switched off gears can be changed as normal but not ...

...change Put in new clutch plate, slave cylinder, master cylinder, clutch fluid, did all the bleeding, changed gear box oil. Gears still stiff. Hard to get first and reverse gears and stiff for other ...

slipping clutch master cylinder brokeon my clutch. was no leaks just the plastic bit had snapt. changed it and now my clutch is slipping. cud it be air inside. it was fine b4 i changed it That could ...

...change the a/c compressor clutch? And do you have to flush the a/c system? changing the clutch does not require flushing system. only time system is flushed is when compressor goes bad but you are ...

...clutch You might have to change your release bearing. When you change this, you have to change the pressure plate, Clutch disk, the pilot bearing as well to assure you of a longer time without ...

...change clutch and pressure plate as well cause that's a usual if changing bearing or clutch pressure plate needs to come off. But as I said I'd check linkage first. Hope this helps clutch ...

...clutch disengages? Can you change gears OK with the engine running and the clutch depressed? When you say it does not engage the plate, do you mean the vehicle does not move? To change gears it must ...