...chainsaw. Used 2 times & pull-cord will not retract. I remove the cover, rewind the cord, re-attach cover & pull to start. Over & over. Finally will start, however, the cord is dangling out in the ...
Question about DCS6401 20 20",64cc Chainsaw 2 Cycle
...CHAINSAW .... pulled out cord too far Hello, Nice little chainsaw for th $$$. I pulled on the cord too far, and too hard, and now the cord does not return inside the chainsaw, and neither can the ...
Question about Consumer Products 9.0 Amp, 14 In. Chainsaw
...CHAINSAW. IF HARD TO PULL CORD WITH SPARKPLUG IN CHAINSAW. IF I REMOVE THE PLUG IT PULLS EASILY. sound like hydraulic lock,try leaving the spark plug out and pull it quite a few times with the spark ...
Question about Consumer Products 9.0 Amp, 14 In. Chainsaw
...pull start cord on ms 192 stihl chainsaw Not that bad. Remove the screws from the starter. Very gently lift it off. Now you will see a grove in the pulley where the starter cord is wound. Fish the ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...pull cord after you get it wound back up? The outer spring should attach to the cord spool in a recess or post. Wedge it to keep it from unwinding, attach the inner cord end and thread it around the ...
Question about 240 Chainsaw 16" Bar -free Extras
...pull cord all the out to start the saw Sounds like the pull cord has become trapped round the spool. Remove starter housing and unwind the pull cord manually off the spool. Then wind the cord back on ...
how to change the pull cor on a CS-3450 chainsaw pull cord YouTube https://www.youtube.com/results?search_query=chainsaw+pull+cord
Question about Pro Mac 605 610 645 650 655 92466
...chainsaw? Pull cord broke. First remove the pull starter housing. The next part is tricky. You'll have to release and unwind the spring that rewinds the pull starter cord. Remember how you do this ...
Question about Pro Mac 605 610 645 650 655 92466
...chainsaw 036 will not start and cannot pull cord more than about 8 inches. feels like compression brake is on tried to pull cord Remove the spark plug and see if you can pull the cord though its full ...
Question about 2-in-1 - 14"/20" Combination Chainsaw in Protective Case-
...turning on chainsaw. The pull cord gets stuck and will not pull smoothly. Whats the problem? if it runs ok after you get it started it could be the starter pulley. the blue max saws have that ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions