Questions & Answers for: chainsaw binding

Question about McCulloch Garden

1 Answer

...Chainsaw engine runs normally, chain stops when placed onto wood surface. Lift it off and chain travels normally, stops at wood contact. Previously had problem with chain binding and stopping (brake ...

Ad

Question about Poulan Garden

1 Answer

...chainsaw and I can't get it back on? Release chain tension. Loosen nut on bar, re-install chain, check for chain not binding when moved by hand, but snug on bar, tighten and you should be back in ...

Ad

Question about Garden

1 Answer

where does the knot go on the pulley of my 162 SE husqvarna chainsaw? The rope did not have a knot, it wrapped around the pulley and back over itself, if you tie a knot it may well come too close to ...

what would make a tohatsu m25c2 hard to pull start? its very hard to pull the start rope. it acts like there is too much compression of something is binding up. try taking apart pulley case that will ...

Hi i have a rancher 455 the chain sprocket on the nose end of the bar is jammed is there any way of un jamming it thanks. you can try wd-40 and work it free but they do bind when they get bent

Question about , No.455 Rancher, 20" Gas - Powered Chainsaw

1 Answer

Chainsaw runs but won't rev up Changed the oiler put back together,will start but won't rev up kinda like it would be if the chain brake was on but checked that and that wasn't it ...

Question about PP5020AV 20 in. 50cc Gas Chainsaw

1 Answer

poulan pp5020av. the pull start binds up. the engine turns over fine. the "dogs" on the flywheel are free. the pull start binds up & won't pull the rope back in. I can remove the pull start, unbind it

Question about PP5020AV 20 in. 50cc Gas Chainsaw

1 Answer

poulan pro 5020 pull start binds up the pull start binds up & won't pull the rope back in. I can remove the pull start, free it up, pull it many times over and it works just fine. but I put it back on

Question about 16" Chainsaw Bar Chain Saw 018 025 Ms 180 250

1 Answer

switch wont go to off 180sthil The switch is really a fairly simple concept that simply moves a strip of metal away from a contact or allows it to connect to a contact to make or break the ignition ...

chainsaw? It just stopped working all of sudden. It wasn't binding or struggling or anything. So I'm not sure why. yes that front bar is the safety (looks like second handle ) it needs pull toward you

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Garden Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

john h

Level 3 Expert

29494 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...