At what mileage does the timing chain need to be replaced? jeep wrangler 2008,3.8 L 6 cil.80,000 miles You change the timing chain now when your Jeep has indicated from a check engine light on. The ...
chain with more than 48 pins will cause excessive slack. Install the crankshaft oil slinger. Replace the oil seal in the timing case cover. Lubricate the tension spring, thrust pin and pin bore in the
...has injector pulse and is getting good fuel, sounds like it jumped timing how do I time it Timing Chain, Sprockets, Front Cover and Seal REMOVAL & INSTALLATION 2.5L and 4.0L Engines Before ...
does it have a timing belt or chain and when does it need to be changed Hello there and than you for choosing fixya Your vehical has a timing chain see the pict and price below around any where around
Question about 2002 Grand Cherokee
how to replace a timing chain tensioner jeep grand cherokee 2002 I was told the violent shaking and the sound from my jeep engine is the primary timing chain tensioner because the chains dont usually ...
Question about 2006 Commander
How to replace the timing chain tensioner on a Jeep Commander/Grand Cherokee/Mercedes fitted with the Mercedes OM642 diesel engine. The chain does not need to be replaced as it is a double chain with
Question about 1995 Grand Cherokee
...grand cherokee laredo 4.0 inline 6 is an interference engine I also don't know if it has a timing chain or a belt You have a timing chain that is good for the life of the engine. The only thing
tension the chains, resulting in noise and/or high timing chain loads. Using Special Tool 6958, Spanner with Adaptor Pins 8346, tighten left and right . camshaft sprocket bolts to 90 ft. lbs. (122 Nm)
Question about 2002 Liberty
How to fix 2002 jeep liberty limited right side tensioner chain is too tight and won't extend to allow installation of tensioner arm and tensioner? How to install right side secondary timing chain ...
...jeep liberty 3.7 timing how to set timing on 2004 jeep liberty 3.7 v6 when replacing the timing chains ill tell you from experience you need to have a shop manual from this set up off one chain ...
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions