...It's hard to say until you start tearing down the engine. Was there any noticable problems with the chain/belt or the sprockets? If you would like to dig into the engine, let me know and I can give ...
...chain,,,the crank sprocket only goes on one way due to the keyway the the key way faces at the 12 clock position and you will see a mark at the same 12 position on the engine block,, there is also a ...
...chain and sprocket removal, position the crankshaft 90 degrees past Top Dead Center (TDC), to be sure the pistons will not contact the valves upon assembly. Carefully rotate the crankshaft clockwise ...
...and the chain,the tensioner,and lower crank sprocket and cam gears,,,,,if the car is in good shape and youre gonna keep it do it,,,if not,,,risk it and let it go,it may never break,,,but i would do ...
chain until the top sprocket matches the final resting place before you bolt down. This can be done by using a drill bit and placing the bit in the hole on the left side of the sprocket and it will go
1996 saturn timing chain tensioner location. want to attempt to tighten rather than replace. it is currently grinding on top bracket It is under the timing chain cover with the chain. if you go to all
How do you replace the water pump on a 1995 Saturn sl1 it is under the timing chain cover. the serpentine belt and all that accompanying stuff has to be removed and/or disconnected. while you are ...
...chain and sprocket assembly - SOHC engine Fig. 3: Insert the timing pin to ensure that the camshaft is at No. 1 TDC - SOHC engine Fig. 4: When the camshaft is at TDC, rotate the crankshaft ...
chain and sprocket removal, position the crankshaft 90 degrees past Top Dead Center (TDC), to make sure the pistons will not contact the valves upon assembly. Carefully rotate the crankshaft clockwise
Usually answered in minutes!
1,310 Questions
953 Questions
963 Questions
862 Questions
606 Questions