the M series if your chain keeps slipping off your sprocket... The Sprocket cover tab (located on the round part of the sprocket cover) isn?t inserted into the saw body tab slot. I hope this helps you
...chain. Insert sprocket cover tab into saw body tab slot and lower sprocket cover into guide bar bolt. Finger tighten guide bar nut onto guide bar bolt. Slowly push guide bar toward saw body until ...
sprocket or chain doesn't Loaned saw 16 inch 3.2 . was returned with chain on backwards. sharpened saw turned chain around. now motor turns but chain doesn't. Is there a clutch that engages when motor
...sprocket, make sure the chain guides are lined up with the groove in the bar and on the tip of the bar, then pull out on the bar (away from saw) to take the slack out of the chain. Holding the bar ...
chain saws have a sprocket that the chain runs on this sprocket is what make the chain rotate on the bar. the bar is the long part that sticks out in front of the motor. you must remove the side cover
...chain is on sprocket and still will not move then you may have a sheared key in the key way if this saw has one, if it does you should be able to see the key way on the end of the shaft coming out of ...
...sprocket on the chain saw. If it appears worn, bent or out of pitch, a new sprocket will be needed.Examine the chain to see if there are any damaged drive links. Replace the chain if too many of the ...
chain does not move Probably the shaft on the sprocket has sheared off.Knox Knolls Outdoor Power EquipmentSpringfield, IL 62704www.knoxknollsope.com Could be the teeth on the sprocket are worn down or
Question about 111409 - 01 6" Branch Wizard Electric Pruning Saw
...sprocket turns without the chain on is that there is evidently enough friction between the shaft that the sprocket mounts on, and, the sprocket. But not enough of a connection to drive the chain. To ...
...chain off the sprocket and pull out from the notch in the bar. Be sure to turn the chain the same direction, otherwise you will be cutting with the back side of the blades. Slide the new chain blade ...
Usually answered in minutes!
300 Questions
155 Questions
148 Questions
117 Questions