Questions & Answers for: McCulloch chain and sprocket

...chain sprocket, or a possible sheared key in the sprocket hub, or a loose mounting nut. Remove the chain and bar, try to turn the sprocket by hand (wear good gloves). There may be some type of ...

...chain onto the sprocket with teeth cutting-edges pointing toward the case on the bottom edge of the bar. Fit bar into extended chain and work under-side of chain into the bar slot all the way around ...

but the drive sprocket will not turn and the chain is adjusted correctly then the centrifugal clutch is bad or the spring is broken. You will have to take the clutch out to see exactly what has broken

...sprocket the chain rides on and see how worn it is. Also make sure the bar is flat up against the side of engine block on that side. You can take the bar off and lay it on a flat surface to insure it ...

...chain will move. I replaced the sprocket. I removed the brake. Same problem. Either the chain is way to tight or it's not getting oil. You could also apply air pressure to hole in bar to make sure ...

How do you get the spocket off? There should be a retaining washer on the sprocket. You will have to spread it apart and slide it off. Once the washer/pin is off the sprocket should come off.

...chain binds on the sprocket and will not turn. have replaced the chain Remove the bar and chain and examine the sprocket teeth for excess wear or other damage. Make sure the chain 'pitch' (the ...

...chain over the sprocket, and lay it into the bar rails, with the cutters sharp edge facing away from the saw on the top of the bar ( the chain rotates clockwise as you are looking at it ) replace the ...

REQUIRE CHAIN SPROCKET-FOR EAGER ****** CHAIN SAW SPROCKET-BRAKE & CLUTCH ARE COME AS SINGLE UNIT I WENT TO SEARS WEB. AND IT LOOKED LIKE YOU COULD BUY JUST THE PART YOU NEED. HOPE THIS HELPED.

chain off the drive sprocket. Adjusting Pawl in place and tightened to remove chain slack, then bar nuts very tight. Fighting this for a year. Solution?? Drive Sprocket needs replacing???? I had a saw