Questions & Answers for: Jeep chain and sprocket

...know the key hole on a 1994 jeep grand cherokee 5.2l engine hi there if you already replaced the timing chain then you must have aligned the crankshaft mark to the mark that is on the cam sprocket

...chain I had trouble getting the new one on - so I rotated the cam sprocket to get it rogether. The Haynes instructions said to line up the timing marks on the sprockets (pointed toward each other), ...

sprocket DOT to 12 oclock if you have the chain lock tool this makes life a lot easier. Both of the cam sprocket have a V6 mark on it they should be at 12 oclock. If everything line up like that u are

chain, crankshaft sprocket and camshaft sprocket with the timing marks aligned Fig. 5 . Apply Mopar(TM) Silicone Rubber Adhesive Sealant to the keyway in the crankshaft and insert the key With the key

chain and sprockets with the timing marks aligned. Tighten the camshaft sprocket bolt to 80 ft. lbs. (108 Nm) for 2.5L engines or to 50 ft. lbs. (68 Nm) for 4.0L engines. For 2.5L engines, release the

...ways to time the cam to the crank. Be sure to check the manual before you install the timing chain or belt. Some timing sprockets are properly timed when the marks face each other.On others, ...

...and see if the bolt is tight,and the belt maybe to tight. what motor do you have .it suppose be a ...

...chain cam sprocket timing. im at alldata.com (or FSM) there are 37 install steps, im not sure what step you want me to pluck out. but here is my guess. step 8 ,9,10 Install both secondary chains onto ...

...chain idler sprocket dot is at 12 o'clock ² primary chain crankshaft sprocket dot is at 6 o'clock ² secondary chain camshaft sprockets "V6" marks are at 12 o'clock ² counter balancer shaft drive gear ...

...sprocket and the chain guide but the bottom section of the chain wont extend enough to accommodate the installation of the Tensioner arm and Tensioner. release the automatic tensioner. strip down and ...