Questions & Answers for: Campbell Hausfeld ch 26

i need to get an operators manual on campbell hausfeld air compressor model WL651500AJ OKGO TO CH POWER.COM PUT IN THE FIRST 6 NUMBERS OF THE MODEL AND IT WILL SHOW UP It's a "6" series ...

...a min. then shuts off and on every couple of min does not get to max psi REPLACE THE PRESSURE SWITCH BUDDY THESE CAN BECOME FAULTY WHICH IS THE CASE OF THIS PROBLEM BUY THEM ON EBAY FOR CHEAP THE ...

...startup?Popped 20amp breaker on startup. clean fuel tank, and lines. just do a standard tune up. check every componet for wear or

I have a brand new CH Model TL050299, 1/2" impact wrench running off a 20 gal, 3.5 HP Devilbliss compressor that delivers 6.8 scfm at 90 PSIG. The compressor regulator is set at 100 PSI, and I am ...

i have a ch 28 gal (wl611700aj) air compressor,it pumps up to 80 psi.wont pump up any further but does keep running.whats your thoughts? Here are a couple of things to check. While the compressor is ...

...money. Usually motor or pump will fail so there are many good tanks around. Or order new from www.chpower.com or www.toolpartsdirect.com ,good ...

what size wire need to used for hook up elect 7hp 60 gallon g5396 Hi GCHEVY, CH recommends their power cord part# EC012902AV. This is a three wire cord, using 10 gauge wires. (1) Black, (1) White, (1)

I have a 6HP 26gallon CH Model VT627102 compressor. The pump shaft seems to be bent. Is there anyway to replace the shaft or am I better off replacing the entire pump? Also, can I put a larger pump on

I have a 115V CH mig/flux welder. I can not get any *********** at all. Has worked fine in past. Am getting gas to the nozzle. Bead looks nice but even with the lightest gage metal, bead just flakes ...

...starts to build pressure and stop building pressure at 25PSI. What do you think is the problem? Check Valve in the tank or the reed valves in the head need to be turned around or ...