Questions & Answers for: Hummer H2 causes fuel gauge malfunction

My dash board guages in my H2 don't come on None of the dash board indicators come on.., Fuel level, speedometer, nothing. Occasionally they might pop on, but not all the time My solution to dashboard

both started these problems at the sametime? Please help me Thanks! for what i had experienced is to change the fuel sender unit and speedometer gauge and recalibrate the IPC to the latest calibration

...gauge is not working i've been researching and it seems to be the fuel pump and something inside the tank....not sure should i get the whole think replace, the tan, fuel filter, fuel pump. wires atc? ...

fuel gauge bottomed out and a ground wire was burnt should i try a new gauge and ground to frame Fix the groung wire. Jack up the vehicle and put on jack stands before going underneath. If you can get

...fuel and electical gauge dials are all the way to the right lower corner when car is running. moves to middle when key is in on position the gauge/ cluster unit needs to be reset. has this thing been ...

i have h2 in my workshop is missfiring. i changed the plugs but still missing i cleaned the valves but still missing i changed the fuel pump but still missing what could the problem? I have been ...

Electrical malfunction of dash guages My 2003 Hummer H2 dash gauges all light up (ABS, Traction Control, E-Brake, etc...) as though there is a short or ground issue. I was driving today and the radio ...

...gauge fault but you might run down the wiring with a volt meter, where the voltage stops is where the issue is. also you might verify you fuel sender is working and check voltage to battery while ...

fuel gauge and tach guage stopped working my tach is stuck at 6 rpm and my fuel gauge is stuck past full Look on ebay for instrument clusters. There are a couple of guys on there that repair them. The

fuel pump and gauge worked for 1 day and back to reading over full again... what else can it be???? plus changed plugs and wires on hummer and still read misfire and i put in an oem old coil and still