Questions & Answers for: Chrysler causes fuel gauge malfunction

fuel filter,o2 sensors, and code read out still says those things are probable causes so i eventually had motor replaced 3 months ago and it began doing same thing..am i correct in assuming that i got

FUEL GAUGE IN MY 2001 CHRYLSER SEBRING TO BOUNCE FROM FULL TO EMPTY AND DING THE LOW FUEL LIGHT ON AND OFF? IT JUST KEEPS DOING IT WHILE THE CAR IS RUNNING. Abraded insulation on the fuel gauge sender

cooling fans won't shut off. either your cooling fan relay is stuck closed or the fan driver in the PCM is bad, causing the relay to stay closed. keep in mind that the temp gauge may actaully be ...

...speed it works fine HAVE IT SCANNED.SOUND LIKE TPS OR THROTTLE POSITION SENSOR FAULTY.IF TPS GOOD.OTHER POSSIBLE CAUSES BAD FUEL.CLOGGED FUEL FILTER.FAULTY SPARK PLUGS AND WIRES.OR BAD IGNITION

...fuel gauge is stuck on half i need to locate my fuel filter This could be the instrument cluster or more likely the sending unit has gone bad. The sending unit is located in the tank and is part of ...

...causes of the code is: â?¢ Leakage exhaust gas â?¢ Rear HO2S malfunction â?¢ IAT sensor malfunction â?¢ ECT sensor malfunction â?¢ Front HO2S ...

...fuel pressure gauge) but there is no injector pulse or spark at the spark plugs, the cause would most likely be a cranshaft position sensor problem, because this will affect BOTH. This scenario ...

...gauge reading. Some have a cove around them to prevent this. Alot of times when someone has the fuel pump replaced they have this problem because float was either bent or not placed in tank properly. ...

...fuel level sender inside the gas tank is defective, this causes the gauge to read empty or just move a little when filled in some cases depending on where the break in the resistor that the float ...

fuel gauge A number of different makes have been damaged by too much sulfur in the gasoline. A malfunction of a unit in the refinery left a lot of corrosive sulfur in some gasoline and it corroded the