Questions & Answers for: cause reduce engine power 2002

...ENGINE POWER REDUCED CAR WILL NOT GO OVER 30MPH Display reads "Engine Power Reduced" and sometimes won't accelerate beyond idle. Other times it accelerates normally. We have not yet noticed a

...cause damage to the engine depending on the nature of the problem. Try changing the gas pedel. I have one if you want to buy it. I will sell it for 120 bucks. Four one nine nine two nine 5229. ...

...engine power displays and in fact the vehicle barely moves 2003 Suburban barely moves under its own power. Low engine power is displayed. Could be the fuel pump in the Gas tank. Mine crapped out and ...

...Reduce Engine Power problem on my 03 Suburban went away when I had to replace the fuel mixing sensor. I damaged the sensor by topping off with E85 (ethanol) by mistake late at night. The vehicle just ...

cause the engine to reduce the power, so the best bet is to have it scanned and Auto Zone scan free of charge. Good luck and hope this helps. Did you plug it in to a computer scanner? It will tell you

...engine power came on i'n my 00 chevy Reduced engine power came on i'n my 00 chevy suburban Ok I would start by checking your shifter to make sure it adjusted right and you can do this by looking ...

2002 suburban overheating while towing car seems to run great on flat terrain. but when I come to a just about any size grade for a considerable distance my temperature gauge starts to scoot up into ...

...engine power reduced engine power comes across the display and I can't accelerate over 45 mph. after killing the engine and sitting 2-3 minutes it restarts and the display goes back to the odometer ...

engine power lights on. There doesn't seem to be any loss of power. Mechanic cleaned the throttle body about 200 miles ago. I would like any suggestions as to cause and to know what type of diagnostic

...engine light came on what does that mean Its telling you your vehicle has been placed in limp mode to prevent damage. You need to have your computer checked for codes that should lead to the issue ...