Questions & Answers for: Buick caster wheels

My steering wheel is locked in place, key will not turn in ignition. Any help?Tried turning the steering wheeling..same problem. Can I assume you curbed your tires when you parked? If so try to turn ...

the controls on the steering wheel stopped working and the radio doesnt work either Replace the clock spring under steering wheel, if applicable to your vehicle The controls on the steering wheel ...

How do i remove my steering wheel? I took out all the bolts buts its still on there, if anyone knows it would be much appreciated! After removing the center nut from the shaft that goes through the ...

The Service traction system, abs and anti lock warning lights keep coming on. I just had 2 oxygen sensors and a wheel hub unit put in. What could be causing this problem? When the wheel hub was put ...

need to find out the numbers of the camber,when the back tires are being aligned .What about the caster,also?and the toe reset numbers .Can you supply me with the numbers I need? CASTER RANGE DEGREE 2

try and fix the alignment by trial and error. I have only seen them set toe this way. not camber or caster. YOU CAN EYEBALL IT BEST AS POSSIBLE, BUT YOU SHOULD GET IT ALIGNED TO BE CORRECT..

Drivers side wheel noise There is a growling, grinding noise from the drivers side front wheel area...worse when turning...is it a wheel bearing? very possible a wheel bearing failing allowing the ...

toe adjustment camber caster What is the nominal specs for the Camber, Caster and Toe for a 1991 Buick Park Avenue base model. camber 0 to 1 degree castor 1 to 2 degrees and toe in 1/ to 1/4 inch as ...

how do I check abs that its wheel sensor 2004 buick rendezvous all wheel drive. I'm getting reading of left rear wheel sensor malfunction. what do I need to check before I change the wheel ...

Turning steering wheel causes electrical failure. Turning steering wheel causes vehicle to shut off, all dash warnings flash. Moving wheel allows restart. There is a big short in the wires that are ...