Questions & Answers for: Toyota Land Cruiser caster and wheel

Question about 2000 Land Cruiser

1 Answer

Only right hand side wheel spins when in 4WD on the front diff on my 1997 80 series landcruiser i believe this is normal as when wheel leaves ground all power goes to the wheel that is not touching ...

Ad

Question about 2006 Land Cruiser

3 Answers

WHEEL STUDS BREAKING The only things that can cause this is either overtightening or a bent axle face or wheel There is another option. The wheel if not factory, might not be sitting over the hub. ...

Ad

Question about 1985 Land Cruiser

2 Answers

...screw down until it hits the stop then back off half to three quarters and tighten the jamnut. The caster is probably out of adjustment on the front axle. If the leaf springs are lifted, sagged out, ...

...wheel alignment on toyota landcruiser hzj75 Camber Left−right error 1°00? ± 45' Caster Left−right error 3°00? ± 1° Steering axis inclination 13°00? ± 45? Camber, caster and steering axis ...

Question about 1998 Land Cruiser

2 Answers

wheel alignment manually after installing steering rack and tie rods on 1998 landcruiser prado Set toe-in with a tape measure and helper, adjust camber with a level, adjust caster withan angle finder.

wheel alignment specs for Toyota Land Cruiser 200. Please help !! Well your Caster should be +2.0degrees to +4.0degrees Your Camber should be at .+2 degrees to +1.7 degrees but I would keep it around

Question about 1994 Land Cruiser

1 Answer

The key is stuck in the ignition cant start. Thanks Turn your steering wheel left or right side. If it moves, then good for you as the key will not be stuck anymore. But if doesn't, it probably means ...

Question about 2006 Land Cruiser

3 Answers

at 120 km per hr the steering wheel starts to shake Balance. go to mechanic to check the wheel alignment and also try to check the steering wheel What you need to do here is get your wheels aligned. ...

I snapped the LHF stub axle, i did notice that when i had my truck off the ground and put it in gear the rear wheels didnt turn, mine is a full time 4x4 so im thinking the transfer case is shot, is ...

ihave a 2011 v8 gxl tray back 122,000 ks not happy with the alloy wheels have had to buy 6 steel wheels as two of the origanal alloy ones have split we have just completed a trip around oz just on bit

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...