Questions & Answers for: caster camber alignment

...camber & caster on a 1997 diamante? You take it to an alignment shop. Put the monkey on them. They have the equipment to get it back to specs. Good Luck, Ned an alignment shop will need to put in ...

...Camber, Caster and Toe-in. Camber Camber is the angle of the wheel, measured in degrees, when viewed from the front of the vehicle. If the top of the wheel is leaning out from the center of the car, ...

...CASTER RANGE DEGREE 2 1/2 P 3 1/2 P - PREFERRED SETTING 3P -CAMBER RANGE 5/16N - 11/16P- PREFERRED SETTING 3/16P - STEERING AXIS INCLINATION DEGREE - TOE IN INCH O STEERING AXIS INCLINATION DEGREE 12 ...

...camber caster on the rear From the factory,no,however, There is a bolt kit available,in a few different sizes from 1 degree to 3 degrees I believe.This is for camber only,no caster adjustment is ...

camber and which one is caster. To adjust the rear camber on these cars you have to have a camber kit. From the angle I am seeing you don't have a camber kit. Also the only way to adjust caster on the

how do i adjust the caster/camber on a 2007 nissan murano? Requires Kingpin camber sleeves. Take to alignment shop or dealer for proper alignment.

...camber caster What is the nominal specs for the Camber, Caster and Toe for a 1991 Buick Park Avenue base model. camber 0 to 1 degree castor 1 to 2 degrees and toe in 1/ to 1/4 inch as different roads ...

tried adjusting the camber caster and toe also think rotors are warped You can continue changing parts at random or take your Chevy to a competent mechanic who can find the real problem and correct it

...caster 0.0 degree tol. 0.75 degree camber -0.8 ± 0.75 degree cross-camber 0.0 degree tol. 0.75 degree (for camber, replace original bolts with camber adjusting bolts) REAR camber -1.2 ± 0.75 degree ...

...r,f.wheel bearing alignment 3deg out on camber and caster on one side all is in good shape check the wheel bearing adjustment again have a wheel alignment done to correct the camber and castor ...