Questions & Answers for: U-Line carry handle Work Safety

Question about Echelon (CO2175FS01) Compact Refrigerator

1 Answer

U-Line CO2175FS-00 Echelon I have a stainless steel U-Line CO2175FS-00 Echelon. The handle is lose. I have taken the door off but cannot figure out how to access the inside of the door to tighten the ...

Ad

Question about 2175BEVS-00 Stainless Steel Beverage Center - Right Hinge

1 Answer

...handle, and about 30-inches in total length. Please tell me the actual overall length and distance between center? Do you carry these? What is the cost for a pair? MUCH appreciated! Mary Hello. Try ...

Ad

not sure of u-line ice maker part number for a BCM45A anyone know what the part number of the ice maker unit is for a u-line bmc45a and where to get a new unit. this one is a 5 wire unit Supco makes a

WATER FREEZING IN ICE MAKER The water tube that carries water into the automatic ice maker keeps freezing solid. I get my blow dryer and thaw out the ice and the ice maker will work for a few days ...

handle on door loose how can i tighten it handle on door loose how can i tighten it Pop out the little plastic buttons. The screws are under them.

Question about Origins 1175R Refrigerator

1 Answer

Fridge door hits counter I had a similar problem where the fridge door could swing 180 degrees but it would hit the handle of the ajacent cabinet after swinging about 130 degrees. I had no luck on the

Question about 15R Compact Refrigerator

1 Answer

...the numbers on motor for replacement most appliance, hvac,and electrical supply stores even online carry ...

Question about Refrigerator Ice Maker

1 Answer

...#ULN-CO75FB-00. Serial # is 991378-08-0471. Any ideas? I found some appliance places but they don't carry. go online to www.searsparts.com and put in your model they might have it ...

Question about 2075WC Wine Cooler

1 Answer

Door not sealing properly The door looks as if it is not level from the hinge side to the handle side. I also can tell that on the handle side the gasket is not completely sealed against the frame. ...

...with the length and width measurements and the thickness should be no less than 1/4 " or 6 mm to carry the shelf load as the shop for a recommended glass thickness but I would not go under 6 mm

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...