Questions & Answers for: carrier code 33

Carrier Heater less than 5 years old--shutdown LED flashes 3 short and 3 long (code 33). Have reset two burner switches and one flu switch but heater will still not fire. Blower comes on within 10 ...

...Carrier Weathermaker SXi. Furnance will not turn on. I shut power off and waited ten minutes and tried to restart. Codes flashing are 12, 31, 32, 33, 41, 42. Can this be started in emergency mode? ...

Carrier 58mxa060 Get code 13 even after a reset. I thought it took three minutes to go from a 33 to a 13. I already replaced the ignitor since this is usaully the problem. The furnance sometimes fires

...carrier 58sta is broke, woke up and it was just blowing cold air. checked to see if the pilot was lit but it doesnt seem to be igniting. led light flashes 3 short and then 3 long cant figure out what ...

Carrier 58STA furnace code 33, no ignition blower stays on. I have a Carrier 58STA furnace. It's getting a code 33 and never trying to ignite. The blower constantly stays on. It is pushing good air ...

...carrier comfort 92 2007 model It started out as code 33 then went to 13 I have it off now after 3 hours do i just turn power on, and will iy work? Thanks Yes, by turning it off this resets the unit. ...

...carrier furnace and the led light is blinking 3 short then three long what is the code code 33 LIMIT OR FLAME ROLL-OUT SWITCH IS OPEN - If open longer than three minutes, code changes to #13. Flame ...

Carrier weathetmaker 8000 58wav flashing code 33 then 13. Blower isnt coming on in heat or cool. Capacitor and fuse are good, is it the motor The only way to be sure is to contact the manufacturer. ...

Carrier furnace 58ZAV115-16 status code 33. Ignites but blower doesn't come on. Shutdown @2.5 minutes. Filter, duct system clean. Blower wheel good. Anything else to check before calling for service? ...

carrier comfort furnace 92 the fan will not stop running, blower will not run, reads code 33, new air filters, no obstruction. Limit switch? Bolw out switch? Blower motor? Any suggestions? read manual