...4. Remove the key from the ignition. 5. After door open chime stops, press the door open button 3 times. 6. After chime, press any fob key twice. 7. After second chime, press any fob key twice again. ...
4-2 order and it turns over but won't start any suggestions? check the ignition coil power source...get a test light & check for power with the key on @ the positive side of the coil...if it does have
...key fob problem it locks car but will not unlock???i have to use key please help!!!! I had a similar problem with a second-hand Mazda2, was intermittent too so the seller kept telling me it was OK. ...
4 cylinder. Turned key and no click sound. I replaced the battery and the car started right up. Drove to work. When leaving, turned key no click sounds, could it be the start switch or starter? Thanks
...locking system on a R reg Mazda 626, I've changed the battery in the key fob and now it doesn't work Dealership unfortunately, They may have to reprogram the FOB to match the codes in the cars ...
...4. Insert key in ignition, Turn key to ON (as far as you can go without starting the engine) and OFF, Remove Key. 5. Repeat step 4 two more times, making sure you remove key each time. 6. Close and ...
...4/cyl/ The immobilzer unit is not allowing my new and only key to start the car. The dealership is saying the entire immobilizer and computer may have to be replaced as the computer will not accept ...
Question about 2000 626
...fob and manual key. each time it switches to unlock ? can't lock mazda 626. tried fob and manual key. each time it switches to unlock ? Did you try locking it to see if it could possibly have a ...
...4 miles and returned home - no problem. Later drove about 10 miles, stopped 3 times, and returned home no problems. Later in the day tried to unlock the door with the remote. It would not unlock. ...
Usually answered in minutes!
544 Questions
410 Questions
356 Questions
269 Questions
277 Questions