...carb settings both high speed and low speed settings. ther is no set setting but to get it to run so it can be adjusted. lightly close the high off then open the low about two turns. try to start if ...
...LOW and HIGH speed screw settings for a Ryobi RCS4040 Chainsaw you those to adjust the carb hi is balls out running , sometimes it sounds sick or spudders when cutting the hi will clean that up small ...
Question about Outboard Motor Boat Bass Fishing Saltwater Base
...Low Speed carb adjust. If it's running fine while idling, adjust the high speed setting. If you have two nobs, its the lower one. May be set wrong. If you don't have two nobs, remove the carburator ...
Low and high speed fuel jet settings for McCullah powermac 145 Can't find the manual right off hand for a 145 for some reason....but... The wahlbro carbs are 3/4 out from lightly seated on high and ...
Question about Outboard Motor Boat Bass Fishing Saltwater Base
...carb settings. turn low speed adjusting screw all the way in then turn it out about 1 1/4 turns out. repeat with high speed screw. when running readjust low speed until proper idle and high speed for ...
Question about Outboard Motor Boat Bass Fishing Saltwater Base
...low speed fuel mixture. The basic settings of the screws should not be lost and if stripping and cleaning the carb each screw should before removing be carefully turned in, counting the turns, until ...
Question about Outboard Motor Boat Bass Fishing Saltwater Base
...crank. The FS45 is a totally different carb configuration, and doesn't have the sump. FS90 carb is an C1Q-131A The FS45 has several carbs that fit:- ...
Question about Outboard Motor Boat Bass Fishing Saltwater Base
...carb for ryobi blower need to set up carby so it will start Set both the high and low mixture settings two full turns back from the closed setting(full clockwise).. Set idle speed for all ahead full. ...
Question about Outboard Motor Boat Bass Fishing Saltwater Base
...carb and expel out carburetor. If not the bad lines, filter, or lines not connected correctly. With fuel primed, turn both high and low speed needles in (CW) until seated, do not tighten. Then turn ...
Question about Outboard Motor Boat Bass Fishing Saltwater Base
...low speed adjustment must be followed with a high speed adjust. Error on the rich side for high speed. Allow engine to reach operating temperature for final adjustment. Other potentual issues, fuel ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions